Fluence FLEX Adapter Gen1/Gen2 (M16)

Complete Fluence Dimming & FLEX Cable Guide w/Diagrams

For connecting a Gen 1 fixture to a T-Connector Cable or 3-Pin Dimming Signal Cable.

This 3-Pin Dimming adapter is designed for use with Gen 2 fixtures that utilize the screw-on (M12) dimming adapter port – it is not for use with the push-lock (M16) dimming adapter port:

All M16 3-Pin Dimming Signal Cables and FLEX cables are designed for use with these Gen 2 fixtures:

• SPYDR 2
• SPYDR 2p
• SPYDR 2i
• VYPR 2x
• VYPR 2p

This Threaded Connector Adapter will allow you to connect your Gen 1 (below) fixture to a M16 T-Connector Cable or 3-Pin Dimming Signal Cable:

• SPYDRx
• SPYDRx Plus
• RAY
• RAZRx

Plug type: Threaded Female x Pushlock Male (not for use with old SPYDRx fixtures that utilize a 3.5mm jack instead of a threaded female twist-lock)

Fluence part #: CDMA-71370

DC FLEX DIMMING CABLE SYSTEM:

These cables provide a low-cost solution to connect multiple power supplies for dimming. When grouped, independent dimming control zones are formed, organized, and isolated in case of problematic environmental factors.

FEATURES AND BENEFITS

• Plug-and-play “T” cables and cable extensions with matching connectors. No wire cutting or stripping is needed, reducing installation time and cost.
• Multiple cable length options are available to create dimming zones with various configurations.
• IP 65 rating ensures full protection from environmental factors from lighting control panel to dimming ports on power supplies.
• 100% compatible for all Fluence products with either pushlock or threaded connectors.
• Ground shield ensures maximum electrical performance for low voltage dimming signals. 

Connector Legend:

• M12 – Latest connector type, found on most new SPYDR 2, FANG, VYPR 3 and RAZRm fixtures
• M16 Push Lock – Predecessor of the M12, this connector type was used on all SPYDR 2 and VYPR 2 fixtures prior to the M12 introduction
• M16 Twist Lock – This connector is used on most SPYDRx and VYPRx fixtures, and all RAZRx and RAY fixtures
• 3.5mm Jack – This connector was used on some the oldest first generation SPYDRx and VYPRx fixtures

If you need any help determining which Fluence cords or accessories you need please contact us and we’ll be happy to help!